IAA | Auxin ELISA quantitation kit

1267 €

AS11 1749  | reactivity: IAA-indole-3-acetic acid (C1')


Info: More information Product suggestions Add review

background | this ELISA assay utilise the principle of competitive binding to measure the concentration of hormone in plant extracts. The IAA-indole-3-acetic acid (C1') hormone specific antibodies are precoated to the surface of the reaction wells. The plant extract sample, containing an unknown amount of hormone, is mixed in the reaction well with a known amount of a tracer to react with a limited number of antibodies in the reaction wells. During incubation the hormone in the sample competes with the tracer for the antibody binding sites. Unbound hormone, tracer and plant extract are washed out of the reaction wells. Following substrate addition which reacts with a tracer bound to the antibody and produces a yellow-coloured product. The absorbance of the sample is converted to concentration of hormone by means of a standard curve which is produced by simultaneously treating standards along with the samples.

reaction wells | antibody coated and blocked, 5pcs for 480 assays, 60 strips with 8 wells

tracer | 20 – 50 µl

tracer diluent | 5x250 mM TBS Tris, 10 mM NaCl, 1 mM MgCl2, pH 7.5 stock + 0.02 % NaN3

reaction and wash solution | 10x TBS stock+0.02 % NaN3

stopping reagent | 2x 5 N KOH stock

substrate diluent | 10x 500 mM NaHCO3 stock, pH 9.6+0 0.02 %. 0 0.02 % NaN3

substrate | 100 mg

standards | 600 µl of each: 15.6 pmol, 7.8 pmol, 3.9 pmol, 1.95 pmol, 975 fmol, 488fmol, 244 fmol, 122 fmol, 61 fmol, 30.5 fmol, 15.2 fmol

assay development time | 4-5 hours

sensitivity | 0.01 to 10 pmol/50 µl

plant extract volume | 50 µl (for using on algae - please inquire)

cross reactivity to skatole is 3.3 %; this antibody will also bind IAA glucosylester. 


Assay parameters

unspecific binding | 2.5 %

midrange(B/Bo=50%) | 0.02-10 pmol; detection limit | 12.25 pg (7 fmol)

linear range of measurment | 15-500 fmol; intraassay variability | 3.6 %

interassay variability | 4.3 %; amount of tracer per assay | 10 ng


The cross-reactions of structurally related auxines and related compunds with antibodies against anti-IAA C1 antibodies

cross reactivity of anti-IAA antibody

Sample clean up

Processing of plant extracts required prior ELISA analysis may vary from plant to plant and will depend upon the actual research objectivce. In most cases pigments and lipophilic material needs to be removed by C18 reversed phase chromatography and subsequently by combined DEAE-cellulose-reversed phase C18 columns. For this purpose Waters Sep-Pack C18 or any anther C18 sorbent can be used as well with satisfactory results, like Millipore, etc.The IAA samples have to be methylated by diazomethane before ELISA analysis, for example by using a commercial reagent 2.0 M Trimethylsilyl)diazomethane solution in hexane (Sigma).

No sample purification is required for algae, cyanobacterial and mosses. 

Example of IAA extraction and purification from plant tissues

Frozen  plant  tissues  are  ground  to  a  fine  powder  under  liquid  nitrogen.  The  powder  is extracted in ice-cold 70% ethanol (10 ml . g-1 FW) containing sodium diethyldithiocarbamate asantioxidant (400 ug . g-1 FW). About 420 Bq (25.000 dpm) of  [2-3H] auxin tracer is added to the extracts to monitor for losses during purification steps  and to validate the chromatographic data. After 2 h extraction, the homogenate is centrifuged (15 000 g, 4°C) and pellets re-extracted by the  same way. The  combined  extracts  are  then  purified  over  a  reversed  phase C18  column  to eliminate chlorophyll and lipids. The extracts are subsequently concentrated to approx. 1.0 ml by rotary  evaporation under vacuum  at 35°C. The  samples  are diluted  to 20 ml with ammonium acetate buffer (40 mM, pH 6.5) containing sodium diethyldithiocarbamate. For the immunoassay dilution  analysis,  the 2 ml of  eluates  is dried in  vacuo  and  re-dissolved  in Tris-buffered  saline (TBS, 50 mM Tris, 10 mM NaCl, 1 mM MgCl2, pH 7.5). Aliquots of these solutions are eitheranalysed  in serial dilutions or mixed with known amounts of IAA standards and  then analysed by ELISAs. The extracts are further purified using combined diethylaminoethylcellulose (1.0 x 5.0 cm) - octadecylsilica  (0.5 x 1.5 cm) columns. IAA and  its amino acid metabolites are  loaded onto a DEAE column cartridge which is then washed with 10 ml dest. water and eluted in 5 ml 6% HCOOH (v/v). The eluates are loaded onto a C18 cartridge and after washing with 5 ml dest. water eluted with 5 ml methanol. The eluates are than evaporated to dryness, dissolved in 50 ul 70% ethanol + 250 ul dest. water and filtered through a HPLC pre-filter (0.22 um). The samples have to be methylated by diazomethane before ELISA analysis, for example by using a commercial reagent 2.0 M Trimethylsilyl)diazomethane solution in hexane (Sigma).


Bulk purchase possible - please inquire.

Accessories: IAA | Auxin ELISA quantitation kit

AS16 ECL-100  |  luminol based, two component, enhanced and stabilized chemiluminescence...
90 €