RbcL II | Rubisco form II positive control/quantitation standard
AS15 2955S | protein standard for quantitation and positive control
|Info:||More information||Product suggestions||Add review|
Standard curve: 3 loads are recommended (0.5, 2 and 4μl).
Positive control: a 2 μl load per well is optimal for most chemiluminescent detection systems. Higher standard concentration needs to be used to allow detection by Coomasie stains. Such gels with higher standard concentration can not be used for quantitation using chemiluminescence.
This standard is stabilized and ready and does not require heating before loading on the gel.
|Expected | apparent MW||
|Not reactive in|
Concentration: after re-constitution with sterile milliQ water final concentration of the standard is 0.15 pmoles/µl
Please, use the 55 kDa size of RbcL for calculations. The pmoles in the standard refer to pmoles of rbcL monomers.
|Selected references||to be added when available, product released in September 2015.|
1.5 µg of total protein extract from Rhodobacter capsulatus (1); extracted with Protein Extraction Buffer PEB (AS08 300); 0.5 pmol of recombinant RbcL I (2), 0.5 pmol of recombinant RbcL II, product AS15 2955S (3) Samples were diluted with 1X sample buffer (NuPAGE LDS sample buffer (Invitrogen) supplemented with 50 mM DTT and heat at 70°C for 5 min and keept on ice before loading. Protein samples were separated on 4-12% Bolt Plus gels, LDS-PAGE and blotted for 70 minutes to PVDF using tank transfer. Blots were blocked immediately following transfer in 2% blocking reagent (GE RPN 2125; Healthcare) or 5% non-fat milk dissolved in 20 mM Tris, 137 mM sodium chloride pH 7.6 with 0.1% (v/v) Tween-20 (TBS-T) for 1h at room temperature with agitation. Blots were incubated in the primary antibody at a dilution of 1: 10 000 (in blocking reagent) for 1h at room temperature with agitation. The antibody solution was decanted and the blot was rinsed briefly twice, and then washed 1x15 min and 3x5 min with TBS-T at room temperature with agitation. Blots were incubated in secondary antibody (anti-rabbit IgG horse radish peroxidase conjugated, recommended secondary antibody AS10 1489, Agrisera) diluted to 1:25 000 in blocking reagent for 1h at room temperature with agitation. The blots were washed as above. The blot was developed for 5 min with TMA-6 (Lumigen) detection reagent according the manufacturers instructions. Images of the blots were obtained using a CCD imager (VersaDoc MP 4000) and Quantity One software (Bio-Rad). Exposure time was 30 seconds.
||| For other applications, usage on species other than stated above or any other questions, please use the LiveChat option or contact us at email@example.com