Can primary antibodies be re-used?

The product information sheet for any given primary antibody specifies the recommended dilution to be used in a certain technique. However, depending on the protein load/well, protein transfer efficiency, and sensitivity of the used detection system, primary antibodies can often be used in much higher dilutions. 

It can be tempting to re-use a primary antibody solution. However, do not be surprised if there is no signal at all, when doing so. All of the primary antibody binds in the first incubation, leaving nothing for the second experiment. In such cases, the primary antibody is often blamed for the failure, but the fact is that the antibody is just not present in the solution to do the job. Re-using primary antibodies is also not recommended in case of quantitative work. 

 

Antibody

How much specific antibody can be found in serum?
How to get an intense signal, using a weak antibody?

 Technical tips

Technical tips

Latest

Calclulated and aparent molecular weight of detected protein is different, why?
2025-10-09 How to chose right loading control for Western blot?
2025-10-06 Calclulated and aparent molecular weight of detected protein is different, why?
2025-10-03 Is an antibody going to work in a technique I am planning to use it in?
2025-09-30 Antibody reactivity to recombinant protein,does not validate antibody specificity in endogenous sample
2025-08-20 Can aggregated antibody be still used?
2025-08-15 Blot Once, Probe Twice - when such approach can be beneficial?
2025-07-31 Why should glycerol not be added, to stabilize antibodies in serum?
2025-06-27 Can methanol in transfer buffer be replaced by a less toxic alternative?
2025-05-12 Will the precipitation of SDS in the stripping buffer affect antibody stripping efficiency?
2025-04-29

Archive


Close
Login / Retailer
Register
Forgot password?